Thermal Management Design
In order to utilize thermal conductivity of these PCBs effectively, designers need to minimise the thermal path by placing high-power devices directly on the substrate with minimal intermediate layers. Use thermal vias or metal-filled cavities under heat-generating components to conduct heat directly to the opposite side or a heat sink.
To prevent solder joint fatigue, designers need to consider the Coefficient of Thermal Expansion (CTE) mismatch with attached materials (e.g., copper, silicon). Moreover, employing a transition layer or compliant bonding can mitigate this fatigue, too.
Electrical and Layout Design
Alumina’s high dielectric constant requires
precise impedance control as trace dimensions critically affect characteristic impedance. In PCB design, maintain minimal trace spacing of about 5-10 mils to leverage alumina’s excellent dielectric strength for high-voltage applications, but ensure adequate clearance based on voltage levels.
Because surface roughness of the metallization can influence conductor loss at high-frequency (RF/microwave) circuits, design grounding carefully and use coplanar waveguide or microstrip lines.
Mechanical and Structural Design
Due to alumina’s brittleness, avoid sharp corners in the substrate outline; use rounded corners (radius >0.5mm) to prevent stress concentration and cracking. Minimise the substrate size and aspect ratio (length-to-width) to enhance mechanical robustness.
The substrate thickness typically ranges from 0.25mm to 1.0mm; thicker substrates offer better mechanical strength but may limit thermal performance in some configurations. Consider the assembly process and define individual boards with laser cutting or scribing in mind during panelization.
Manufacturing and Assembly Considerations
You need to choose the appropriate metallization process: Thick Film (screen-printed paste) is cost-effective for simpler layouts, while Thin Film (sputtered/plated) or Direct Bonded Copper (DBC) offers finer lines and better thermal performance for high-power applications.